Crosley Model AC-7 and AC-7C Radio Service Data Sheet
May 1930 Radio-Craft

May 1930 Radio-Craft

May 1930 Radio-Craft Cover - RF Cafe[Table of Contents]

Wax nostalgic about and learn from the history of early electronics. See articles from Radio-Craft, published 1929 - 1953. All copyrights are hereby acknowledged.

Ralph D. Mershon - RF Cafe

Ralph D. Mershon

Have you ever heard of a Mershon condenser? Me neither, but this Crosley Model AC-7 radio used one (or more), whose Radio Service Data Sheet was published in the May 1930 issue of Radio−Craft magazine, mentions it. Ohio State University alums are likely familiar with the name Mershon, if not the man. Ralph D. Mershon was, among other things, an early manufacturer of electrolytic capacitors. The data sheet mentions a propensity of Mershon capacitors to experience breakdown of the electrolyte when the radio is not used for many months. Rejuvenation is necessary via an included prescribed procedure to ensure effective operation in removing the 60 Hz hum in the audio.

Crosley AC-7 and AC-7C

Crosley AC-7 and AC-7C Radio Service Data Sheet, May 1930 Radio-Craft - RF CafeThis receiver employs one (first) stage of tuned "push-pull" R.F., a second stage of R.F. amplification (in which circuit oscillation is pre-vented by a "losser " resistor R12 of 750 ohms and the reversed tickler winding T of L2), a regenerative detector, and the usual two stages of transformer-coupled A.F. amplification. The tubes used are as follows: V1, V2, V3, V4 and V5, X-'99s; V6, '12; V7, BH-type gaseous rectifier. (The specified tubes must be used.) The filaments of the amplifier and detector tubes are connected in parallel, and the filament current is obtained from the rectifier V7 and high-voltage winding S1 of the power transformer PT. The manner of obtaining grid bias for these tubes is indicated in the detail circuit.

An insulating film on the plate of the Mershon condenser is built up at the factory; but this gradually breaks down if the receiver is not in use for some time. To build up a film on the plates the receiver is put into operation with all tubes in their respective sockets. At the start of the reconditioning process, resistor R16 should be turned to extreme left, and resistor R1 set mid-way. Operate the set for ten minutes to half an hour, noting the current reading on the milliammeter MA; the value for correct operation of the set is between 55 and 60 milliamps. As the current increases, R16 should be adjusted to maintain this reading, A greater length of time than fifteen minutes is seldom required before the set begins to play well. If C10-C11-C12 is defective, the Mershon unit should be replaced.

 

 

Posted November 3, 2023
(updated from original post on 9/21/2016)

Radio Service Data Sheets

These schematics, tuning instructions, and other data are reproduced from my collection of vintage radio and electronics magazines. As back in the era, similar schematic and service info was available for purchase from sources such as SAMS Photofacts, but these printings were a no-cost bonus for readers. There are 227 Radio Service Data Sheets as of December 28, 2020.