Standardized Wiring Diagram Symbols & Color Codes
August 1956 Popular Electronics

August 1956 Popular Electronics

August 1956 Popular Electronics Cover - RF CafeTable of Contents

Wax nostalgic about and learn from the history of early electronics. See articles from Popular Electronics, published October 1954 - April 1985. All copyrights are hereby acknowledged.

When this "Standardized Wiring Diagram Symbols & Color Codes" feature appeared in a 1956 issue of Popular Electronics magazine, semiconductors were just coming into common use. Therefore, only the simplest components like a diode and bipolar junction transistor (BJT) are included. In fact, the only two types of diodes shown are vacuum tube and selenium. The semiconductor diode is labeled as a crystal rectifier. There is no light emitting diode (LED), field effect transistor (FET), metal oxide semiconductor FET (MOSFET), integrated circuit (IC), or other commonly used modern device. Note also that the "Receptacle 117V" does not show a safety ground connection. The "Vibrator" was a device commonly used to convert direct current (DC) to alternating current (AC). About the only people who will find a use for this information are those who service and/or restore vintage electronic equipment, but it's still a good thing to make available for historical purposes.

Standardized Wiring Diagram Symbols & Color Codes

 - RF CafeWiring Diagram Symbols

The standardized wiring diagram symbols chart has been updated recently to reflect recent additions of semiconductor components, including the solid state diode and transistors. Notice the similarity between these symbols and many of the ones in the ARRL Handbook chart.

Resistor Color Code

RETMA Color Code Chart

The ohmic value of a resistor can be determined by means of the color code. There are two standard methods of indicating this value.

In Fig. A. the body (A) and end (B) indicate the first and second digits of the value while the dot (C) indicates the multiplier to be used. The tolerance of the unit is indicated by the end color (D). For example. if the body (A) is green the number is 5; if the end (B) is grey the second number is 8. If the dot (C) is red the multiplier is 100 or two zeros should be added. The resistor is then a 5800 ohm unit. If the end (D) has no color, the tolerance is ±20%.

Resistor Color Code Chart - RF CafeIn Fig. B, the first two stripes indicate the first two digits; the third stripe the multiplier; the fourth stripe the tolerance. Thus, if stripe (A) is green, (B) is grey, (C) is red, and (D) is silver, the resistor is a 5800 ohm, ±10% unit.

Capacitor Color Code

Capacitance is given in μμfd.

Capacitor Color Code Chart - RF Cafe

Capacitor Marking Chart - RF CafeColors have same values as on resistors, except as indicated in tables. Colors (A) and (B) are for first two digits; (C) is for multiplier. (D) is for tolerance. (E) and (F) give voltage rating in hundreds of volts; (E) is used only for ratings less than 1000 volts, (E) and (F) for first two digits of ratings 1000 volts or more. Values of colors for (E) and (F) are same as in resistance values. (G) is class or characteristic of capacitor. (H), (I), and (J) give temperature coefficient. (G), (H), (I), and (J) are not listed in the tables, since this information is seldom needed by the average home builder.

 

 

Posted January 27, 2023
(updated from original post on 9/26/2016)