What You Should Know About Film Resistors
January 1965 Electronics World

January 1965 Electronics World

Janaury 1965 Electronics World Cover - RF Cafe  Table of Contents 

Wax nostalgic about and learn from the history of early electronics. See articles from Electronics World, published May 1959 - December 1971. All copyrights hereby acknowledged.

Metal oxide resistors have been around since the early 1960s. We take them for granted now, but prior to their appearance on the market the mainstays of electronics resistance elements were carbon composition and wirewound resistors. Carbon compound types are very inexpensive and are acceptable for a wide range of applications, but they have a bad habit of shifting value over time, particularly when subject to repeated heating and cooling cycles. Wirewounds (WW) are a good alternative when cost and physical space are not issues, but WW's can be tricky or even impossible to use when frequencies get above a few tens of megahertz because of inductance limitations. Metal film resistors exhibit much better long term stability than carbon composition types, and can operate well at frequencies in the hundreds of megahertz while dissipating a few watts of power. The television industry benefitted greatly, as this 1965-era Mallory in Electronics World magazine advertisement points out.

What You Should Know About Film Resistors

What You Should Know About Film Resistors, January 1965 Electronics World - RF Cafe

Mallory Tips for Technicians

Mallory Distributor Products Company

P.O. Box 1558, Indianapolis, Ind. 46206

a division of P. R. Mallory & Co. Inc.

Mallory metal film resistors - RF Cafe

If you've been looking inside some of the recent model television sets, chances are that you've noticed some unusual-looking resistors. Especially in the sizes readily identifiable as under 10 watts. You'll probably find them in spots where you're used to seeing small wirewound.

There's a good reason. These are metal oxide film resistors. And the reason they're making such a hit is that they have as good stability and life as wire-wounds - but they cost only about half as much in most values.

Typical stability test data - RF Cafe

Typical stability test data: 10,000-hour load cycling test. Average resistance change is less than 1%!

What's different about them?

First, they're made differently. A thin layer of tin oxide is evaporated onto a high quality ceramic rod, at high temperatures. A spiral groove is then cut, by a highly precise automatic machine, to produce a resistance path with the desired ohmic value. Then the end connections are applied and the whole works gets a coating of silicone finish. You can get a lot higher resistance values, size for size, than with wirewounds, because you're not limited by the problems of winding hair-thin wires. Top resistance for the 4, 5 and 7 watt sizes is 120,000 ohms; for 2 and 3 watts, 56,000 ohms. Standard tolerance is 10%.

Second, they behave differently. Their stability is really terrific, We've run them with on-off load cycling for 10,000 hours and measured changes of t less than 1%. They'll take heavy brief overloads without damage, aren't bothered by humidity or vibration. And they're noninductive up to 250 mc. The name to ask your Mallory Distributor for is the MOL film resistor. He has them in 2, 3, 4, 5, and 7 watt ratings, in popular resistance values. And when you need a higher wattage (up to 200 watts) ask him for Mallory vitreous enamel resistors - you can't beat them for cool operation and stable life.

 

 

Posted October 9, 2023
(updated from original post on 2/5/2015)