Tips for Technicians, by Mallory
February 1969 Electronics World

February 1969 Electronics World

February 1969 Electronics World Cover - RF Cafe  Table of Contents 

Wax nostalgic about and learn from the history of early electronics. See articles from Electronics World, published May 1959 - December 1971. All copyrights hereby acknowledged.

Akin to how the National Company ran a long series ( a couple hundred altogether) of infomercial type ads in the ARRL's QST magazine from the 1930s through the 1950s, Mallory had its "Tips for Technicians" run in Electronics World (and maybe other electronics magazines of the era). Being a major capacitor manufacturer, its ads featured brief tutorials on various types of capacitors, their characteristics, and how they should be used in circuits - both for new design and when replacing capacitors in existing equipment.

Here is a May 1967 Tips for Technicians, a February 1969 Tips for Technicians, and a May 1969 Tips for Technicians.

Why some filter capacitors develop hum and some don't.

Tips for Technicians, February 1969 Electronics World - RF Cafe

Mallory Type TC78A Electrolytic Capacitor - RF CafeAluminum electrolytic capacitors are widely used as filters in DC Power Supplies. This is because of their large capacitance in relatively small size. All in all, they do an efficient job of reducing ripple (hum) to acceptable levels.

However, all electrolytic capacitors are not alike. This is often why some types seem to allow hum to rise to objectionable levels more quickly than do others. In order to understand why, we must investigate actual construction methods.

As you know, electrolytics are basically made by depositing a film of aluminum oxide on aluminum foil to form the positive anode. The oxide is the dielectric. A semi-liquid electrolyte surrounds the anode and is actually the negative cathode. In order to connect this semi-liquid cathode to a terminal, a second piece of aluminum foil is used. This is often called the cathode, but it is not. It is actually only the cathodic connection. (The preceding describes a "polarized" electrolytic capacitor.)

Mallory Type FP Capacitor - RF CafeWhen high ripple currents are applied to polarized electrolytics, a thin oxide film forms on the so-called "cathode". It begins to assume the characteristics of a second anode. This in turn, has the same effect as placing two capacitors in series. Consequently, overall capacitance is reduced. Inevitably hum increases.

This action is especially noticeable in electrolytics which use plain foil as the" cathode". This is simply because the oxide builds up over a relatively small area.

Mallory avoids this problem by etching the" cathode" on electrolytics. As a result, oxide build-up is spread over a vastly increased area. Therefore, ripple currents are maintained at very low levels for very long time periods.

Of course etched "cathodes" cost a lot more to make. But you get them from Malloy at no extra cost.

Meanwhile, see your local Franchised Mallory Distributor for capacitors, resistors, controls, switches, semiconductors, and batteries. Or write Mallory Distributor Products Company, a division of P. R. Mallory & Co. Inc., Indianapolis, Indiana 46206.

Don't Forget To Ask 'Em "What else needs fixing?"

Circle No. 91 On Reader Service Card

Mallory: What else needs fixing?" - RF Cafe

 

 

Posted November 17, 2017